To be honest, I wasn’t as surprised as I thought I would be when trying out this mic. Note: XLR connections will also yield a better audio quality since they are designed to reduce noise. Sadly, the Rode NT1a doesn’t come with a PAD or High–Pass filter, it’s just the bare microphone, but it is a great performer and it does what it’s supposed to do. Lastly, if you are someone who is looking to make music from home, run a podcast with guests, or anything similar, then definitely get an Audio Interface with more than one Input and purchase separate XLR mics. In this article I will be comparing the Rode NT USB and the Rode NT1a, and I will give you my honest opinion on which microphone you should choose… Spoiler alert, there’s a clear winner. What this means is that if you have a room that sounds poorly, it is going to capture that in the recording far more audibly than an SM58 will. It can also you make your vocals a bit more sibilant. Microphone Rode NT1-A Problems No Signal or too much signal Forum Index » AudioBox USB : Author. It has a slight boost at around 150Hz and at the 6k to 12kHz range, with a deep cut at the high-end; all this means that it will be actually quite bright sounding, which is what I referred to earlier by saying that people found it to be a bit harsh at times. This microphone is good for recording singing, as well as spoken word; such as podcasting and voice-over, YouTube videos, etc. avoid distortion when loud volume is used. An extraordinary find! The only issue is that you would need to invest in an Audio Interface, and this will definitely be more expensive than getting the USB microphone, but it’s a much better setup in every way you look at it. Rode is known for making extremely high-quality equipment at reasonable prices, and the Rode NT USB is no exception to this rule, except for one thing, which I’ll mention in a second. I wrote a post comparing USB microphones to XLR ones, their pros and cons, and much more, that you should definitely give a quick read before you decide what to do. The Rode NT USB on the other hand, doesn’t have a Gain Control, which doesn’t make any sense, plus if you ever want to be able to record multiple sources, you would end up having to purchase an Audio Interface with XLR microphones anyway. Given this, there is a lot of room for playing much louder the clip LED is a quite nice indicator. Lastly, it works on Windows and Mac OS based computers, as well as the Apple iPad, and all you have to do is plug it in and that’s it. In this article I will be comparing the Rode NT USB and the Rode NT1a, and I will give you my honest opinion on which microphone you should choose… Spoiler alert, there’s a clear winner. For spoken word applications or for quiet singing it works super well, however when recording instruments that are a bit too loud, or any other loud sound source for that matter, even if the signal doesn’t clip it will sound as if it’s clipping. (Rode NT1-A distortion) Hello there, I have sent a track for mastering recently (to a top engineer) and have found that it came back with low-mid distortion in the vocals, mainly on louder parts. The shock mount is metal, when most included ones are made of plastic. USB microphones are simple to use, but if you ever want to upgrade you will need to ditch the microphone entirely and get new equipment. It’s got some weight to it and it doesn’t feel at all flimsy or delicate. Now, you might have noticed that it doesn’t come with a Gain dial, which for a mic in this price-range is just ludicrous. NT1A comes with an amazing shock mount, a pop screen, a dust cover, an XLR cable, and more! As far as singing along to music with a mic set at that level, that's why you have a DAW mixer and headphone levels to play with. As I mentioned earlier, it all depends on your personal taste. Some people might find that it enhances their voice, while others may find that it makes their voice sound horrible and shrill. This is also something that works well with acoustic guitars, since that high-end boost really opens up the higher frequencies, making the guitar sound better. Recording piano † To record a piano using a single microphone you should place the mic approximately 60cm (2’) above the centre of the sound board, aimed slightly towards the front of the piano. Some people praise it as if it were the best microphone to be ever created and they even compare it to other ones that are in a much higher price range. Let’s get started with the basic differences between the two… Rode NT USB vs Rode NT1-a The main difference between … Rode NT USB vs Rode NT1-a; There’s a clear Winner! Like I mentioned, it includes a pop filter, which is rare since most microphones don’t include one. Position the microphones near the guitar amplifier cabinet around 4 to 6 inches for dynamic microphones and 8 to 12 inches for a condenser microphone. I've worked in a music studio a couple of years back and now I mostly record at home and try to learn as much as I can about producing music and about the gear that is required to do so. Rode NT USB vs Rode NT1-a; There’s a clear Winner! I found it great for recording vocals, acoustic guitar and electric guitar, but to be honest… once you get to this level of microphone it gets hard to really find one that doesn’t sound great. See below: In short, USB microphones are more “beginner friendly” than XLR ones for the simple fact that they are plug n’ play devices and that no additional equipment is required to use them. When looking at the build quality I have to say that it’s quite good; not AS good as the Rode NT1a, but as I mentioned in the beginning, they are two completely different beasts. This means that you can choose to hear only what’s coming out of the PC, to only hear the direct signal from the Mic, or a blend of those. I actually do like the high-end boost a bit since it gives it a more “airy” sound, plus it helps the tracks to better fit in the fix, like I mentioned. It’s absolutely fantastic and it’s built to last. The main difference between these two microphones is that the Rode NT connects to the computer via USB, while the Rode NT1a has an XLR connector on the bottom. The presence boost could make your recordings too bright. For years now I've been interested in music production. Rode NT1A matched pair or unmatched NT1 pair for stereo field recording. Condenser microphones are more sensitive than dynamic mic, so it should be positioned farther. As far as the pickup pattern goes, it’s a Cardioid microphone, meaning that it only picks up sound coming from the front while rejecting anything hitting it from the sides or rear. Also, having no Gain dial makes it a bit of a pain to set the levels correctly. Here’s a link to Amazon where you can check the price and the Reviews of the Rode NT USB. The RODE-NT1A will be more sensitive to environmental sounds The RODE NT-1A is naturally a much more sensitive microphone than the SM58. When I play louder, it is possible lower the channel to avoid unwanted distortion. † To record a piano using a matched pair of NT1-As using X/Y stereo technique, the matched Read More » If you want a microphone that has an identical build quality but sounds a bit darker, then check out the Rode NT1. Hey there! The reason why the Rode NT1a is so good is because it will give you a very accurate representation of what is being recorded, meaning that it should easily fit within any mix. Required fields are marked *. It all comes down to your own preferences, what kind of tone you’re going for, etc. The two controls on the side are for the headphone volume, which comes in handy when you want to do zero latency monitoring, and the Direct mix control between mic input and source output. Your sample track appears to be clipping on the consonants. It comes with a pop filter, a tripod desk stand, a ring mount, and a storage pouch. sincerly, You can find that one in my post about the best microphones under $300. What I’ve found over the years is that having that boost just gives the sound -especially vocals- a pre-produced sound and the tracks usually need a bit less EQing to fit in the fix. Last Updated on September 18, 2020 by Facundo. You can control the levels from your PC however, but this isn’t ideal since it simply takes too much time. Just a friendly reminder that political discussion, (including "offhand" and 'sideways' commenting) is.